MOTIONER is the inertial motion capture system developed for RAM. The computer captures the dancer’s movements via 18 sensors attached to the dancer’s body. In general, motion capture systems are very expensive and very accurate, or very cheap and very inaccurate. To address this problem we designed one which is relatively low in cost and fairly accurate.
MOTIONER is an open source project. Check the following link to GitHub Wiki to make and use your own MOTIONER. The latest application and source code can be found there as well. GitHub Wiki
MOTIONER software by YCAM InterLab and Yoshito Onishi is licensed under the Apache License, Version2.0.
MOTIONER software is made with openFrameworks.
MOTIONER Arduino, Processing sketch and mbed code by YCAM InterLab and Yoshito Onishi are licensed under the GNU GPL(General Public License) v3.0.
Creative Commons License
MOTIONER hardware related documents (Schematics, Eagle files, Solder
Stencil Mask, Drawing of MOTIONER base, MOTIONER pcb board, vacuum
case and strap) by YCAM InterLab, Yoshito Onishi is licensed under a Cre-
ative Commons Attribution-ShareAlike 4.0 International License.
Creative Commons License
This Document by YCAM InterLab, Yoshito Onishi is licensed under a Cre-
ative Commons Attribution-ShareAlike 4.0 International License.
